Oh boy: I am a “NEW USER”, therefore incapable of uploading images.Īnother problem the current configuration causes is the HOME position.
IF the X axis component was reversed, or the laser unit was relocated to the other side of the rail the laser beam would be able to travel the entire 400mm. As far as it will travel up the Y axis it about the 350mm mark. With the laser located on the front side of the X axis member there is physically no way the laser could reach the 400mm mark. The Y axis side rail (with markings) has the 400mm marking close to the end rail (with the Atomstack name). The traveling carriage (with the laser attached) is the X axis, and yes, it does have full travel.
The orientation I’m using is that the rail with the Atomstack name is the rear and the front rail has the yellow warning label.
0 kommentar(er)
